Schism XV parallel loop

Three parallel channels with boost.
Two effect loops plus a third clean channel.

4.7 " X 3.7" X 1.34" (lid included in measurement) Powder coated Cast Aluminum Enclosure.

Thicken up your tone with two similar pedals or shape new sounds mixing contrasting effects together. Run a single effect in each loop or multiple pedals in series.

Burr-Brown™ low distortion, low noise performance operational amplifiers with true FET input stages, fully independent channels, and 15V positive/negative voltage rails.

"RET/DRY" toggle switches allow you to change the operation of the CH1 and CH2 bypass stomps when bypassed. With the toggle flipped to "DRY" the stomp switch changes the channel from loop active to dry buffered signal. With the toggle set to "RET" the stomp switch changes the channel from loop active to muted. Though the effect send is at ground (muted) the effect return is connected to the output mixer. This allows delay/echo trails to remain after the loop is bypassed.

"NRM/INV" switches prevents signal cancellation due to phase opposition caused by inverting effects.

When active CH3 is in parallel with CH1/CH2
CH3 does not have effect loop send/return jacks.

Knobs control level only, they do not blend wet/dry.

The master stomp switch is wired for true bypass operation and removes all active circuitry from your signal chain.

Ground lift on loop returns.

9Volt negative center DC 200+mA with a 5.5 x 2.1 mm barrel plug. No internal battery.

To avoid incurring an escalated price on all customers an AC adapter is normally excluded. Each unit will only ship with a negative center output 120V AC adapter upon request.

CNC cut case graphics and circuit board.

A killer pedal for sculpting sound.